Hughes Direcway DW6000 - Manual (Page 41)

Chapter 2 • Installing the indoor equipment
1033295-0001 Revision 2
17
Obtain IP address and test
Ethernet connection
1. Restart the PC so it obtains an IP address from the DW6000.
Or use the command ipconfig /renew from a DOS
command line prompt.
2. The embedded DHCP server assigns IP address =
192.168.0.2 to the PC. The default Gateway address is set to
192.168.0.1. Figure 12 shows a sample Windows TCP/IP
Properties screen. (These may vary among different Windows
operating systems.)
Make sure the installer PC can communicate with the DW6000
over the Ethernet connection. Enter
Ping <192.168.0.1> at a
DOS prompt. Figure 13 shows a successful attempt; Figure 14
shows an unsuccessful attempt. If the PC fails to ping the
DW6000, there are issues with either the PC’s NIC or TCP/IP
configuration.
Note: In countries outside North America, the DW6000 may be
plugged, with a physical adapter, directly into a 220 V outlet.
Different countries may have different standards and requirements.
Note: Whenever the LEDs do not function properly as described
above, check to be sure you have the correct power supply, PN
1031105-0001.
Figure 12: