Supported nnm configurations, Supported hp computing products, 2 supported nnm configurations – HP zl User Manual
Page 9: 3 supported hp computing products
hp toptools for openview nnm
user guide
The installation of HP Toptools permits the selection of management components installed. Any combination of the
four components (“desktops”, “servers”, “printers” or “hubs and switches”) is supported for operation with this
bridge. In addition, “Advanced Configuration” should be selected at the end of the installation and discovery
categories (IPX, WMI, etc) enabled as appropriate*. Discovery should NOT be scheduled. Note that you may be
prompted to overwrite existing files during the installation. You MUST choose to overwrite existing files or the
installation will fail.
*Unless you intend to use HP Toptools for Hubs and Switches management features, do not enable 'Topology'
discovery.
1.3.2 Supported nnm Configurations
The following versions of NNM are supported by HP Toptools for OpenView NNM:
HP OpenView NNM 6.20, or 6.1 for NT4.X/Windows 2000, HP-UX 10.20 and 11.0, and Sun Solaris 2.6
including full support for NNM-NT remote consoles and limited support for web consoles.
•
•
Operating Systems are supported with the following patches:
Windows NT 4.0
HP-UX 11.0
HP-UX 10.20
Sun Solaris 2.6
Service Pack 4 and above
PHCO_14775 (Japanese)*
PHSS_18891 PSOV_02435
PHCO_17317
PHSS_19465 PSOV_02493
PHCO_19666
PHSS_20129 PSOV_02535
PHCO_22453
PHSS_20255 PSOV_02563
PHCO_22923
PHSS_20623 PSOV_02603
PHKL_18543
PHKL_23002
PHSS_17535
PHSS_21982
PHSS_22341
PHSS_22946
* Only required for support of Japanese U.I.
Refer to the HP Network Node Manager web site for the latest
(support.openview.hp.com).
1.3.3 Supported hp Computing Products
The following HP computing products are supported by HP Toptools for OpenView NNM:
• HP Netservers and Toptools Remote Control cards
• HP IA-64 servers
• HP Blade GSP cards
• HP Visualize workstations
• HP Kayak workstations
• HP Vectra desktops
• HP Omnibook notebooks
• HP Advancestack and Procurve networking products
• HP Blade switches
• HP NetVectra clients
HP Toptools Remote Control card, Advancestack, and Procurve devices support firmware agent software. Firmware
may be updated using HP Toptools. HP Netserver, Visualize, Kayak, Vectra, and Omnibook products support HP
Toptools agents that are loaded into the Operating System. All agents and firmware are provided with purchased
products and may also be downloaded from the HP website. Upgrading agents and firmware to current versions is
highly recommended.
Page
9