FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 100)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 100
Using the Image Darkness option
Use this option to set the overall darkness of the printed image by increasing or decreasing
the amount of heat used by the Printhead when printing.
Step Procedure
1 Lighten the printed image by clicking the down arrow to enter a negative
value and decrease the amount of Printhead heat.
OR
Darken the image by clicking the up arrow to enter a positive value and
increase the amount of Printhead heat.
Caution #1: For best results, make slight adjustments of only
±
4 to
avoid accidentally over-adjusting the Printhead heat.
Caution #2: If the positive value is set too high, the Print Ribbon
may jam or even break. The maximum adjustment range is
±
100.