FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 188)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 188
Cleaning the Card Feed Rollers (continued)
Step Procedure
4 a. Insert the Cleaning Card into the Card Hopper, above the Card Input Tray,
as normally done with any other type of card.
b. Be sure, however, that the shortest non-adhesive end of the Cleaning
Card enters the Printer first and that the sticky side is facing UPWARD.
Caution: If the card is inserted with the sticky side facing
downward, it will stick to the Card Input Tray and will not feed.
5 Once the Cleaning Card is properly inserted into the Card Hopper, hold down
the On/Cancel button and push the Cleaning Card into the Printer until the
second gray feed roller grabs and begins feeding the card.
6 a. Continue to hold down the On/Cancel button until the Cleaning Card has
fed completely through the Printer.
b. Repeat this cleaning procedure as needed.
c. After the cleaning procedure is finished, re-install media, close the
Printer's Top Covers and turn the Printer power OFF and ON to reset the
Printer.
7 Be sure to use either clear tape or masking tape. (Note: If the cleaning kit is
not available, adhesive tape is also an effective method for removing lint and
debris from the Rollers.)
Caution: Do not use duct or strapping tape. These adhesives leave
a gummy residue behind.
8 a. Open the lid and use the Pause/Resume and On/Cancel buttons to rotate
the main feed Rollers, while applying the tape.
b. Alternatively, use 99% pure alcohol wipe. Do not use these wipes for
every cleaning because this could eventually deplete the tact from the
roller
’
s rubber.
(Warning: Do not use alcohol to clean the Cleaning Roller Assembly.)