FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 84)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 84
Resolving the Image Placement problems (continued)
Step Procedure
2 Verify the Image Placement setting is set correctly.
a. Open the Printer Control Panel from the Computer.

If using Windows 95/98/ME, right click on the Pro-LX Card Printer Icon
and select Properties.

If using Windows NT 4.0 right click on the Pro-LX Card Printer and select
Document Defaults.

If using Windows 2000/XP, right click on the Pro-LX Card Printer and
select Printing Preferences.
b. Click on the Calibrate tab.
c. Click on the Settings button.

If the white border is on the leading edge of the card, adjust the Image
Placement value by
–
2.

If the white border is on the trailing edge of the card, adjust the Image
Placement value by +2.
d. Click on OK.
e. Run a self-test.
f. If the white border is diminished, continue the adjustment until it is gone.
3 Adjust the Card Guide Bar as needed.
a. Open the Top Print Cover.
b. Loosen the two screws that hold the Card Guide Bar in Place.
c. Remove the back cover.
d. Locate the Card Guide adjustment screws.

If the white border is on the side of the card closest to the front side plate,
turn both Card Guide Adjustment Screws clockwise
¼
- turn.

If the white border is on the side of the card closest to the backside plate,
turn both Card Guide Adjustment Screws counter-clockwise
¼
- turn.