FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 8)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 8
Reviewing Pro-LX Sequence of Operations (continued)
Step Process
15 The Print Cover Sensor checks for a closed state.
16 The Ribbon Drive Motor engages.
17 The Image Data is burned by the printhead until image data is depleted. All Stop.
18 The Thermistor engages Printhead Cooling Fan to maintain proper operating
temperature.
19 The Headlift Motor engages.
20 The Print Headlift Sensor detects an open state.
21 The Print Headlift Motor disengages.
22 The Print Stepper Motor engages.
23 The Print Ribbon drive engages.
24 After the Ribbon advances a few encoder clicks, assume the Ribbon is free of
cards. All Stop.
25 Repeat steps 10 through 24 for the appropriate number of color and overlay
panels.
26 The Print and the Lamination Drive Stepper Motors engage.
27 The Lamination Card Sensor detects presence of card. All Stop.
28 The Lam Stepper engages.
29 The Card feeds back to the Flipper Table.
30 The Flipper Clutch engages
31 The Flipper Table rotates 180 degrees
32 The Flipper Table Clutch disengages. All Stop.
33 The Print and Lam Stepper Motors are activated.
Continued on the next page.