FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 101)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 101
Using the Image Placement option
Use this option to adjust the lengthwise or horizontal position of the printed image on a card
so it appears centered. (Note: When adjusting this value, keep in mind that cards always
remain in the same landscape orientation while moving through the Printer.)
The diagram (below) represents how the printed image will move in relation to the fixed card
position as a positive or negative Image Placement value is entered.
Step Procedure
1 Click on the left arrow to enter a positive value to move the printed image
toward the leading edge of the card or the card output to the side of the Printer.
OR
Click on the right arrow to enter a negative value to move the printed image
toward the trailing edge of the card or the card input to the side of the
printer/encoder.

Printed Image Direction: The arrows on these buttons indicate the direction
the printed image will move on the card. The maximum adjustment range is
±
100. As a rule, 10 equals about .060"/. 16mm, which is about twice the
thickness of a standard CR-80 size card.

Maximum Adjustment Range: The maximum adjustment range when
adjusting this option to avoid over-adjusting.
Caution: If positive value is set too high, the Print Ribbon may break.
Direction card travels through printer
Rear of Printer
Card Output
Side of Printer
(Leading Edge
of Card)
Card Input
Side of Printer
(Trailing Edge
of Card)
Front of Printer