FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 41)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 41
Reviewing the Bottom Line LCD Error / Status Messages (continued)
Message Cause
Lam Error/Out The overlaminate is either out or an error has occurred. See the
Resolving the Lam Error/Out Error Message procedure in Section
2, page 57.
Lam Jam/Out Error The overlaminate has either become jammed in the Printer Rollers,
stuck to the surface of the card, broken or has run out. See the
Resolving the Lam Error/Out Error Message procedure in Section
2, page 57.
Lam Ready Indicates Printer is ready to laminate. See the Using the Lamination
tab Section 3, page 134.
Lam Temp = X% Indicates the laminator is heating or cooling to its target
temperature. When the Lam Temp = 100%, the target temperature
has been reached and lamination will begin. See the
Selecting the
Lamination Dwell Time and Temperature in Section 3, page 138.
Lam Turned Off Indicates laminator is OFF. The laminator can be turned off by
setting Switches 4 and 5 of the Printer's internal switches down
(towards the circuit board). See the
Using the Lamination tab
Section 3, page 134.
Laminating Indicates Printer is laminating. See the Using the Lamination tab
Section 3, page 134.
Roller-dn Failed The Lamination roller is unable to lower. See the Resolving the
Headlift Error Message procedure in Section 2, page 49.
Roller-up Failed The Lamination roller is unable to rise. See the Resolving the
Headlift Error Message procedure in Section 2, page 49.
Sensor Calibrate Indicates the Lamination Sensor is calibrating. See the Using the
Lamination tab Section 3, page 134.
Wrong Lam Type
Error The wrong overlaminate is installed. See the Resolving the Wrong
Ribbon error procedure in Section 2, page 62.
Continued on the next page