FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 109)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 109
Adjusting the Laminator
Adjust the laminator's Card Guide Rail if the PolyGuard patches are being applied too closely
to or overlapping a card's top or bottom edge (as the card travels through the Printer.
Step Procedure
1 Loosen the two screws that fasten the Card Guide Rail to the Printer's main
chassis.
2 Move the Card Guide Rail slightly toward the rear of the Printer (in the opposite
direction that the patch is to move in) if the PolyGuard patch is being placed
more toward a card's top edge. See the next page).
Continued on the next page
Screws
Card Guide Rail Card Flipping
Mechanism