FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 90)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 90
Using the DIP Switch (continued)
Step Procedure
4 When completed, turn OFF the power to the Printer to reset the operating mode
of the Printer.

The first illustration (below) shows all eight (8) switches in the normal OFF
position.

The second illustration (below) shows Switches No. 1,2 and 3 in the ON
position. (Note: The Ribbon Sensor calibration without the need of a PC).
(Note: Refer to the DIP Switch Settings table on the next page for additional
diagnostic selections.)
1
1
2
2
Amp x
xxx
435
802-9
o
f f
Amp x
xxx
435
802-9
o
f f
3
3
4
4
5
5
6
6
7
7
8
8