FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 146)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 146
Using the Overlay / Print Area (continued)
Step Procedure
6 Use the Defined Area arrows to navigate back and forth from area to area.
(Note: The active area will always be highlighted with a dotted outline.)
a. Define another area by clicking on the Defined Area UP arrow.

Another .2" x .2" / 5mm x 5mm area will appear in the lower left-hand
corner. (Note: This is the location in which all newly defined areas will
first appear.)

Up to 5 areas can be defined; however, additional areas cannot be added
until the most recently created area has been moved or sized. (Note: For
this reason, size and position each area as it is created.)
b. Define areas for both the Front and Back sides (as needed) if printing onto
both sides of the card.
c. Delete an area by using the Defined Area arrows to select the area and click
on the Delete button. (Note: If all areas are deleted, the K Panel Resin
options will automatically be deselected.)