FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 102)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 102
Using the Print Length option
Use this option to reduce or lengthen the overall printable area in order to optimize edge-to-
edge printing toward the trailing edge of a card. (Note: When adjusting this value, keep in
mind that cards always remain in the same position while moving through the Printer.)
The diagram (below) represents how the print length will move in relation to the fixed card
position as a positive or negative Print Length value is entered.
Step Procedure
1 Click on the left arrow to enter a positive value to reduce the print length and
move the end of the printable area more toward the leading edge of the card.
OR
Click on the right arrow to enter a negative value to increase the print length and
move the end of the printable area more toward the trailing edge of the card.

Printed Image Direction: Notice the arrows on these buttons indicate the
direction the length of the printable area will move on the card.

Maximum Adjustment Range: The maximum adjustment range is
±
100. As a
rule, 10 equals about .030"/. 8mm, which is about the same as the thickness of
a standard CR-80 size card.)
Direction card travels through printer
Rear of Printer
Card Output
Side of Printer
(Leading Edge
of Card)
Card Input
Side of Printer
(Trailing Edge
of Card)
Front of Printer
-