Fostex VF80EX - Manual (Page 103)

103
Advanced Operations (VF80EX)
Inserting a program to the chain play list
You can insert a program to a desired step in the
current chain play list.
Follow procedure steps 1) and 2) on page 9 to show the
“Chain Play List” screen.
(i.e. enter the setup mode and select “Chain Play List” .)
Use the [JOG] dial (or the [CURSOR] keys) to select a
step where you want to add a program and press the
[ENTER/YES] key.
The program number set to the selected step starts
flashing. If you select
“C02” on the left screen example
below, “P02” starts flashing.
1
Use the [JOG] dial to select “INS” and press the [ENTER/
YES] key.
You can now select a program to be inserted. Initially,
“P01” flashes.
As you can see by comparing the two screen examples
above, the programs set to the second and subsequent
steps slide down automatically.
3
Use the [JOG] dial to select a program to be inserted,
and press the [ENTER/YES] key.
In the example shown below, program 6 (P06) is inserted
to step 2.
4
<Note>
You can enter up to 99 programs to the play list. If you
are trying to enter a program to tyhe play list where 99
programs are already registered,
“Void! Play List is Full” is
shown and the operation is canceled.
After inserting all desired programs, press the [EXIT/
NO] key.
The “Chain Play List” screen is dismissed and the display
returns to the “Select Menu” screen where the current
option of the “Chain Play” mode setting is flashing.
5
If you want to insert a program to another step, repeat
the same procedure above.
<Note>
If you insert the desired program(s) to the chain play
list when the
“Chain Play” mode is set to any option
but “Off” , the “Chain Play” setting automatically
changes to “Off” (the default).
Therefore, to execute chain play after editing the
chain play list, you must set the
“Chain Play” mode
appropriately again.
After setting the “Chain Play” mode appropriately, press
the [EXIT/NO] key repeatedly until exiting the setup
mode.
6
2