Fostex VF80EX - Manual (Page 46)

46
Mixer Functions (VF80EX)
2
3
4
5
6
1
Flashing
Setting effect send levels
You can set send levels from Tracks 1 through 6 to the
internal A.S.P. effect processor.
Press the [EFFECT] key to bring up the send level
setting screen.
If you have not edited any track parameter for effect
send, EQ or pan setting after turning on the power last
time, the message prompting to select a track ("
Select
TRK! ") flashes, as well as the [TRACK STATUS/TRACK SEL]
keys for Tracks 1 through 6 on the panel flash.
If you have edited any track parameter for effect send,
EQ or pan setting after turning on the power last time,
the icon for the previously edited track is highlighted,
showing that it can be edited.
Select the desired track by pressing the correspond-
ing [TRACK STATUS/TRACK SEL] key (or using the
[CURSOR / ] keys).
The icon of the selected track is highlighted, indicat-
ing that you can edit it.
In the default settings, the send levels for Tracks 1
through 6 are "
00 " while the level for Master is " 80 ."
Use the [JOG] dial to adjust the send level value.
The knob icon also rotates according to the level value.
When the level is set to "
00 ", no signal is sent to the effect
processor.
• Editable tracks: Tracks 1 through 6
• Level range: 00 through 99 in 1 step
• Default level: Tracks 1 through 6: 00, Master: 80
To edit the send level for another track, repeat steps 2
and 3 above.
To edit the effect send master level, press the [STA-
TUS/SEL] key of the master to highlight the master
level icon, and then use the [JOG] dial to edit the value.
The default level value is " 80 ."
After completing send level settings, press the [EXIT/
NO] key.
The LCD display returns to the Normal screen.
Effect send level setting screen
Effect type/parameter setting screen
Effect send pre/post setting screen
<Hint>
When editing the loop effect setting, pressing the
[EFFECT] key after turning on the power cycles
the screen between " Effect send level setting
screen ", " Effect type/parameter setting screen " and
" Effect send pre/post setting screen ", as shown
right.
<Note>
If you select one of effect types L39 through
L44, the "Effect type/parameter setting
screen" is shown and pressing the
[EFFECT]
key does not change the screen.
This is because effect types L39 through L44
are only used as insert effects and do not have
the "Effect send level setting screen" and
"Effect send pre/post setting screen"
See "Advanced Operations" on page 84 for
details about the insert effect.