Fostex VF80EX - Manual (Page 131)

131
Save/Load of Song data (VF80EX)
Press the [ENTER/YES] key.
The selected track (“01”, in this example) is set, while
the screen changes as below.
9
10 Use the [JOG] dial (or the [CURSOR] keys) to select
(highlight) another desired track to be loaded and
press the [ENTER/YES] key.
In the example below, track 2 (02) is selected (of
course, you can select whichever track you want).
Depending on the load type (“One” or “Select”) se-
lected in step 7) above, the screen shown is slightly
different.
When the load type is “One” When the load type is “Select”
When you set the load type to “One”, the load desti-
nation program number for the secondly selected
track is one higher than that for the firstly selected
track. That is, the load destination program number
is counted up each time you select a track.
On the contrary, when you set the load type to “Se-
lect”, the load destination program number for the
secondly selected track is same as the firstly selected
track. That is, all selected tracks are loaded to the
same program.
11 Press the [ENTER/YES] key.
As with the firstly selected track, the secondly selected
track (“02”, in this example) is set.
13 When completing selecting all desired tracks, press
the [ENTER/YES] key while holding down the
[RECORD] key.
The display shows “Data Loading!” while tha remain-
ing data amount (in MB) is counted down. You can-
not cancel loading once it starts. Wait for a while until
loading is completed. Loading more amount takes
more time. When completing loading, “Completed!”
is shown, while the audio CD is automatically ejected
from the CD-R/RW drive.
12 Operate the same procedure as above foe selecting
other track.
14 Press the [EXIT/NO] key to exit the Setup mode.
<Hint>
When a CD-RW disc on which any data is recorded
is set, if you perform step 7 above (i.e. pressing the
[ENTER/YES] key when “CD-DA” is flashing), “Not
Empty!” appears on the display, followed by the
screen for selecting whether erasing recorded data
or ejecting the disc.
• If you erase recorded data:
Press the [ENTER/YES] key while “ERASE” and
“Sure?” are flashing.
After the key press, the display changes as follows
and the VF80EX starts erasing the data.
As the erasing process is going on, the number of
flashing
“ * ” increases.
When erasing is completed, the display shows the
same screen which appears when pressing the
[EN-
TER/YES] key after selecting “CD-DA” on step 7 above.
So follow the same procedure from step 8 on page
123.
Increases as the process
progresses.
• If you eject the disc:
Use the [JOG] dial to make “Eject” flashing and then
press the [ENTER/YES] key.
The disc is ejected, while “Insert Disk!” appears on
the screen.
When inserting a blank disc, you can go on the next
step (see the procedure described above).
Flashing Flashing
Flashing Flashing
<Note for loading>
If you select track 1 (01) and then track 3 (03), as
shown in the screen example below, track 3 (03) is
loaded to program 6.
However, if you select track 2 (02) after selecting tracks
1 and 3, track 2 is loaded to program 6 while track 3 is
reloaded to program 7.