Fostex VF80EX - Manual (Page 34)

34
Basic Recording/Playback (VF80EX)
3
1
During playback, this counter shows the current
recorder position in real time.
2
The time (or bar/beat) stored is shown here.
1
2
3
4
5
6
7
The time (or bar/beat) stored is shown here.
Flashing
Auto punch in/out function
You must set the punch in and out points before per-
forming auto punch in/out recording.
You can set the points either during playback and
while stopped. In the following description, we assume
that the
“ABS” time base is selected.
• Setting the punch in/out points on the fly during playback
(or while stopped)
Press the [AUTO PUNCH/EDIT] key while holding down
the [SHIFT] key.
The screen for setting the punch in/out points appears.
At the point at which you want to set the punch in point,
press the [SETUP/F1] key while holding down the
[SHIFT] key.
“In Point Stored!” appears briefly, and the point is stored
as the punch in point.
At the point at which you want to set the punch out point,
press the [TIME BASE SEL/F2] key while holding down
the [SHIFT] key.
“Out Point Stored!” appears briefly, and the point at which
you carry out the operation above is stored as the punch
out point.
<Note>
Set the punch in point earlier than the punch out point.
• Setting the punch in/out points numerically
While the recorder is stopped, you can set the in and
out points by entering the time numerically.
While stopped, press the [AUTO PUNCH/EDIT] key
while holding down the [SHIFT] key.
The screen for setting the punch in/out points appears.
Press the [ENTER/YES] key while the punch in point
value is highlighted on the screen as above.
Now you can edit the punch in point value.
Initially, the
“seconds” value starts blinking, showing
that it can be edited.
Move the blinking value by using the [CURSOR / ]
key and enter the desired value using the [JOG] dial.
After completing editing the time value, press the [EN-
TER/YES] key.
The edited time is stored as the punch in point.
Use the [CURSOR ] key to highlight the punch out
point value, and press the [ENTER/YES] key.
Now you can edit the punch out point value.
Flashing
Enter the desired value with the same method as en-
tering the punch in point, then press the [ENTER/YES]
key.
The edited time is stored as the punch out point.
After storing times for both points, press the [EXIT/NO]
key.
The LCD returns to the Normal screen.