Fostex VF80EX - Manual (Page 57)

57
Recorder Functions (VF80EX)
current scrubbing position
4
3
2
1
Digital scrubbing
Digital scrubbing can be done between 0x and 1x
speed without changing the pitch while the VF80EX
is stopped.
You can scrub audio track by track. The level enve-
lope of the scrub track is shown on the screen, allow-
ing you to locate the beginning of a song or interval
of songs easily.
Furthermore, you can use the position located by
digital scrubbing as an edit point for the track editing
or auto-punch in/out.
Performing digital scrubbing
While stopped, press the [WAVE FORM SCRUB] key.
The VF80EX enters the scrub mode, and the display
shows the screen below.
Press the [TRACK STATUS/TRACK SEL] key for the
track you are going to scrub.
The level envelope of audio recorded on the selected
track is shown. When the VF80 is stopped, "
<STILL> " is
also shown.
By rotating the [JOG] dial, you can scrub audio of the
selected track.
The vertical line in the center shows the current posi-
tion, and you can hear scrubbing audio from this posi-
tion to either the forward or backward direction.
When rotating the
[JOG] dial clockwise, " Scrub > " is
shown. When rotating the [JOG] dial counter-clockwise,
" < Scrub " is shown.
The cursor (the vertical line) moves while scrubbing,
while the time value (or bar/beat) of the current posi-
tion is shown in realtime.
If you want to scrub another track, repeat steps 2 and 3.
Storing the digital scrub point
You can store the scrub point to the Start, End or To
point for track editing functions (such as Copy, Move,
Paste and Erase), or the auto-punch in point.
• To store the scrub point to the Start point:
Press the [SETUP/F1] key while holding down the [SHIFT]
key.
" Edit Start Point Stored! " is shown briefly and then the
scrub point is stored to the Start point for track editing.
• To store the scrub point to the End point:
Press the [TIME BASE SEL/F2] key while holding down
the [SHIFT] key.
" Edit End Point Stored! " is shown briefly and then the scrub
point is stored to the End point for track editing.
• To store the scrub point to the To point:
Press the [UNDO/REDO/F3] key while holding down the
[SHIFT] key.
" Edit To Point Stored! " is shown briefly and then the scrub
point is stored to the To point, which can be used as the
starting point of Paste or the auto-punch In point.
• After storing the point, press the [EXIT/NO] key.
The display returns to the Normal screen that was shown
when finishing scrubbing.
<Hint>
• You can also store the point by pressing the [ENTER/
YES] key after highlighting START , END or TO by
using the [CURSOR ] or [CURSOR ] key.
• By pressing the [| / MARK] key while holding down
the [SHIFT] key, you can store the scrub point to a mark
memory.