Fostex VF80EX - Manual (Page 25)

25
Basic Recording/Playback (VF80EX)
PHANTOM
ACCESS
PEAK CH ON/OFF
L R
GUITAR GUITAR
LINE MIC LINE MIC MIN MAX
MASTERING TRAINING
EFFECT EQ PAN
SCENE SEQ. SCENE TRACK
TRIM TRIM
MIX PARAMETER
PGM FADER MAP
ON/OFF
2TRK MODE
FOOT SW ST OUT PHONES INPUT A
BOUNCE
INPUT B
PEAK CH ON/OFF
UNBAL UNBAL
BAL BAL
F1 F2 F3
EDIT
REC EFF
OFF ON
MIDI
OUTPUT INPUT OUTPUT INPUT
POWER PHANTOM S/P DIF / DATA
Rear panel
Foot switch (mode 8051)
Amplifier + Speakers etc.
Microphones (Dynamic
or condenser type)
Headphones
Guitar processor
Electric bass Electric guitar
Digital equipment (CD, MD, DAT etc.)
AC outlet
Sequencer
PC w/sequence software
Top panel
Connections of external equipment
You can connect various sound sources and external devices to the input and output connectors of the
VF80EX as shown in the example below. When making connection, make sure that the
[MASTER] fader
is set to the lowest ( “
∞
” ) position and the [PHONES] knob to the left most ( “MIN” ) position. Otherwise,
your speakers or headphones may damage by the audio noise generated when connecting cables.
<Note>
You cannot use both the [BAL] and
[UNBAL] connectors on INPUT A and
INPUT B simultaneously. Plugging the
[UNBAL] connector disconnects the
[BAL] connector.
<Note>
Do not power on the machine with non-speci-
fied foot SW connected to the foot SW jack.
When powering on the machine with non-
specified foot SW (latch type foot SW, etc.)
connected to the foot SW jack, there is a case
that the machine does not correctly boot up
with
“No Drive!” alert message. In such a case,
power off the machine once, disconnect the
foot SW and then power back on.