Fostex VF80EX - Manual (Page 148)

148
Specifications (VF80EX)
Maintenance
Specifications
Recording/Reproducing
Recording Medium : 3.5 inch, hard disk (E-IDE type)
Recording Format : FDMS-3 (*)
Save/Load Format : FDIO-1 (**)
Sampling Frequency : 44.1kHz
Quantization : 16-bit linear (Non expanded)
A/D Converter : 20-bit 64 times, over sampling, Delta-Sigma
D/A Converter : 24-bit 128 times, over sampling, Delta-Sigma
No. of Recording Track : 8 real tracks + 16 additional tracks
*2 tracks for simultaneous recording (Maximum)
Vari Pitch Control : +/- 6%
Crossfade : 10msec.
Recording/Reproducing Frequency : 20Hz ~ 20kHz
Input/Output
Input A, B
Connector : ø6mm Phone jack (Unbalanced)
: XLR-3-31 type connector (Balanced)
Input Impedance : 50k Ω or more (Unbalanced)
: 1k Ω or more (Balanced)
Standard Input Level : -50 ~ +4dBu
Phantom Power (XLR only) : +48VDC (Setting of ON/OFF with PHANTOM switch)
HEADPHONE
Connector : ø6mm TRS Phone jack
Load Impedance : 10 Ω ~ 50 Ω
Output Level : 20mW or more (at 32 Ω )
STEREO OUT L, R
Connector : ø6mm Phone jack
Load Impedance : 10k Ω or more
Output Level : -10dBV
S/P DIF DIGITAL IN
Connector : COAXIAL
Format : IEC 60958 (S/P DIF)
DIGITAL OUT
Connector : COAXIAL
Format : IEC 60958 (S/P DIF)
MIDI IN/OUT
Connector : DIN 5 PIN
PUNCH IN/OUT
Connector : ø6mm Phone jack (An optional FOOT SW Model 8051
can be connected.)
Cleaning the exterior
* For normal cleaning, use a soft dry cloth.
For stubborn dirt, moisten a cloth in diluted detergent, wring it out firmly, and wipe the dirt off.
Then polish with a dry cloth. Never use solvents such as alcohol, thinner or benzene, since these will
damage the printing and finish of the exterior.