Garland 200 - Manual (Page 49)

Part # MCOSM06 Rev 1 (11/03/08) Page 49
Convection Oven Motor Assembly
1. Assemble the motor mount plate, insulation, and motor
mount plate inner together by fastening four flat head
m.s. 1/4-20x21/2" into the four holes noted on the above
drawing.
2. Secure each flat head m/s/ 1/4-20x21/2" with a flat washer
and three hex nuts 1/4-20.
3. Attach the motor mounting plate to the motor. Insert the
four flat head m.s. 1/4-20x21/2" though the mounting tabs
on the motor as shown. Secure with two hex nuts 1/4-20.
4. Insert the shaft of the motor though the hub of the blower
wheel. Space the wheel 1/4" away from the inner motor
mounting plate.
5. Secure the blower wheel to the shaft of the motor by
tightening the two set screws on the blower wheel hub.
Use a torque wrench and tighten to 180 inch pounds for
proper securing.
6
2
1
3
5
9 8
4
5
7