Metz Mecablitz 54 MZ-3 - Manual (Page 64)

will only be re-established after a subsequent (3 sec.)
continuous bleep.
Bleep signals associated with settings in „A“ auto-
matic mode:
• A short bleep as an acoustic alarm is generated in the
auto flash mode of the mecablitz if the selected aper-
ture and ISO setting exceed the permissible light con-
trol range. The auto aperture of the mecablitz is then
automatically adjusted to the next permissible value.
Setting the bleep function:
• Press the Select button repeatedly until the icon
flashes.
• Turn the setting disk and switch on the bleep function.
„ON“ appears on the LC display of the mecablitz. This
setting will be stored when the setting disk is briefly
pushed in the direction of the arrow. The selected set-
ting will be automatically stored after 5 seconds if the
setting disk is not pushed.
Deactivating the bleep function:
• Press the Select button repeatedly until the icon
flashes.
• Turn the setting disk and switch off the bleep function.
„OFF“ will then appear on the LC display of the meca-
blitz. Push the setting disk briefly in the direction of the
arrow to store this setting. The selected setting is auto-
matically stored after 5 seconds if the setting disk is
not pushed.
12.2 Locking and unlocking the controls (key
function) (Fig. 14)
The key function locks the Mode and Select buttons, as
well as the setting disk, from inadvertent resetting.
To lock the Mode and Select buttons press them simul-
taneously for approx. 3 seconds until the
key
icon appears on the display.
To unlock the Mode and Select buttons press them
simultaneously for approx. 3 seconds until the
key icon disappears from the display.
Special functions
Funzioni speciali
Funciones especiales
64
Fig. 14 / Figura 14 / Grabado 14
700 47 0078-A4 PDF GB-I-E 30.09.2008 14:12 Uhr Seite 64