Metz Mecablitz 54 MZ-3 - Manual (Page 84)

after 5 seconds if the setting disk is not pressed. The
arrow symbol alongside „EV“ ceases to flash. The set
value is displayed on the LC display of the mecablitz.
Deactivating manual flash exposure correction:
• Turn the setting disk until the arrow symbol appears
alongside „EV“ on the LC display.
• Press the setting disk. The arrow symbol alongside
„EV“ starts to flash.
• Turn the setting disk until the displayed correction
value is extinguished on the display.
• Press the setting disk in the direction of the arrow to
confirm deactivation. If the setting disk is not pressed
the function is automatically deleted after 5 seconds.
The arrow symbol alongside „EV“ ceases to flash.
Manual flash exposure correction is only possi-
ble if the camera supports this function! If the
camera does not support this function, the cor-
rection value can be adjusted on the mecablitz,
but cannot become effective!
Transmission of a correction value for flash exposure from
the mecablitz to the camera is only possible in TTL mode
with an SCA 3xx2 adapter which supports this function.
With some cameras, manual flash exposure corrections
must be adjusted on the camera (see the operating
instructions for the given camera). In this event the
mecablitz will not display a correction value.
Some cameras permit manual flash exposure corrections
to be completed on the camera or on the flash unit.
Please refer to the operating instructions for the given
camera or the SCA adapter to establish which setting
has priority.
☞
84
Exposure corrections
Compensazione dell‘esposizione manuale
Correcciones de exposición
700 47 0078-A4 PDF GB-I-E 30.09.2008 14:12 Uhr Seite 84