Intel 21555 - Manual (Page 139)

21555 Non-Transparent PCI-to-PCI Bridge User Manual 139
List of Registers
Table 44. Downstream Memory 0, 2, 3, and Upstream Memory 1 Setup Registers
These registers are used to program the type and size of their respective upstream and
downstream BARs.
Bit Name R/W Description
0
Type
Selector
R
Read only as 0 to indicate memory space is requested by the
corresponding memory BAR.
2:1 Type R/(WS)
Type of space requested. Allowable values are:
• 00b to indicate that the space requested by the BAR may be located
anywhere in memory space
• 01b to indicate that it must be mapped below a 1MB boundary
• 10b for Downstream Memory 3 Setup register to request a 64 - bit BAR
Other values may yield unpredictable results.
Reset value is 00b.
3 Prefetchable R/(WS)
Indicates whether the space requested by the BAR is prefetchable.
• When 0, not prefetchable.
• When 1, prefetchable.
• Reset value is 0
11:4 Reserved R Read only as 0.
30:12 Size R/(WS)
These bits specify the size of the address range requested by the BAR.
• When a bit is 1, the corresponding bit in the BAR functions as a
readable and writable bit.
• When a bit is 0, the corresponding bit in the BAR functions as a
read
- only bit that always returns zero when read.
• Reset value is 0 (disabled), except for Downstream Memory 0 Setup
register, whose reset value is 7FFFFh (request 4 KB).
31 BAR_Enable R/(WS)
BAR enable.
Bit [31] of the Downstream Memory 0 Setup register always reads as 1,
indicating that the BAR cannot be disabled. When a bus master attempts to
write this bit with a 0, the 21555 returns all bits {31:12] of the setup register
as 1s (request 4KB).
• When the Upper 32 Bits Downstream Memory 3 Setup register bit [31]
is a 1, the corresponding BAR is enabled as a 64
- bit register, and this
bit is part of the size field for the 64 - bit BAR.
• When 0, the corresponding BAR is disabled and reads as 0, with the
exception noted above.
• When 1, the corresponding BAR is enabled, with size and type
specified by this setup register.
• Reset value is 0, except for Downstream Memory 0 Setup register that
has a reset value of 1.
Offsets
Downstream
Memory 0 Setup Downstream
Memory 2 Setup Downstream
Memory 3 Setup Upstream
Memory 1 Setup
Primary byte AF:ACh B7:B4h BB:B8h CB:C8h
Secondary byte AF:ACh B7:B4h BB:B8h CB:C8h