I-Tech Company CMS 6R4 Series - Manual (Page 105)

10-7
Command Reference Guide
/DPL Set Plugs to Default State
Sets all four switched outlets to their user-defined default state. For
information on setting outlet defaults, please refer to Section 5.5.5.
Availability: Supervisor Only
Format: /DPL[,Y] [Enter]
Where ,Y is an optional command argument, which can be included to
suppress the command confirmation prompt.
Response:
Verbose: Lists plugs to be defaulted, and then displays the command
confirmation prompt. If "Y" is entered in response to the prompt, the
CMS-6R4 will display the "Processing - Please Wait" message and then
display the status screen when the default operation is complete.
Terse: 5, if Y, unit will respond with H.
/E Erase Buffer
Erases data from the buffer for a specified port(s). Note that erased data cannot
be recovered.
Availability: Supervisor Only
Format:
/E[,Y] <x> [x] [Enter]
Where:
,Y (Optional) Suppresses the "SURE? (Y/N)" (command
confirmation) prompt.
x Is the number or name of the port buffer(s) to be cleared. To
apply the command to several ports, enter a space character or
a plus sign (+) between each port number. To apply the
command to a range of ports, enter the numbers for the first
and last ports in the range, separated by a colon character (:).
To apply the command to all ports allowed by your password,
enter an asterisk character (*).
Response:
Verbose: The unit will display the command confirmation prompt. If Y is
entered in response to the prompt, the unit will erase the specified buffer
and then respond with "OK".
Terse: 5, if Y, the unit will respond with 0.
Example: To clear the buffer for Port 3, access the Command Mode from
a port and account that permit Supervisor commands, and type /E 3 [Enter].