I-Tech Company CMS 6R4 Series - Manual (Page 47)

5-25
Confi guration
5.5.2.2. Telnet Port Parameters
The Telnet Port Parameters Menus are used to configure the Telnet Port, and
select parameters such as the Response Type and Command Echo. To access
the Telnet Port Parameters Menus, proceed as follows:
• Web Browser Interface: Click the "Setup" button to access the
Setup Menus, and then click the "Telnet Parameters" button; the Telnet
Parameters menu will be displayed as shown in Figure 5.13.
• Text Interface: Type /N and press [Enter] to access the Network Port
Parameters Menu (Figure 5.10.) From the Network Port Parameters
menu, type 12 and press [Enter]. The Telnet Port Parameters Menu will
be displayed as shown in Figure 5.12.
Note:
Settings for network parameters depend on the configuration
of your individual network. Contact your network administrator for
appropriate settings.
The Telnet Port Parameters Menu allows the following parameters to be
defined. Except where noted, all parameters listed here are available via both
the Web Browser Interface and Text Interface.
• Service: Enables/Disables the Telnet port. When the Telnet Port is
disabled, you will not be able to communicate with the unit via Telnet.
(Default = On.)
Note:
In the Web Browser Interface, the Service parameter is
accessed via the Telnet Parameters button on the left hand side of the
SetUp menu. In the Text Interface, the Service Parameter is located in
the Network Parameters Menu, which can be access by typing /N and
pressing [Enter].
• Port Number: Selects the TCP/IP port number that will be used for
Telnet connections. The Port Number can be set to any valid number
except 80; this is because 80 is the default port number for the
CMS-6R4's Web Server feature. (Default = 23.)
Note:
In the Web Browser Interface, the Port Number setting is
accessed via the Telnet Parameters button on the left hand side of the
SetUp menu. In the Text Interface, the Port Number setting is located
in the Network Parameters Menu, which can be access by typing /N
and pressing [Enter].