I-Tech Company CMS 6R4 Series - Manual (Page 29)

5-7
Confi guration
5.5. Configuration Menus
As described in the sections that follow, configuration parameters can be
selected via the Web Browser Interface or Text Interface. Although the
Web Browser and Text Interface provide two separate means for selecting
parameters, both interfaces allow access to essentially the same set of
parameters, and parameters selected via one interface will also be applied to
the other.
Web Browser Interface: Click the "Setup" button to gain access to the
configuration menus; a row of buttons will be displayed along the left hand
edge of the screen. Note the following:
• Newly selected parameters will not be activated until you click the
"Apply" button.
• Click "Switch Panel" to return to the main status screen.
Text Interface: Refer to the Help Screen (/H), then enter the appropriate
command to access the desired menu. Note the following:
• To exit from a parameters menu, press the [Esc] key.
The following sections describe options and parameters that can be accessed
via each of the configuration menus.
Note: Configuration menus are only available when the Supervisor
Mode is active. Configuration menus are not available if you have
logged in using a password that does not permit access to Supervisor
Level commands.
5.5.1. The System Parameters Menu
The System Parameters Menus allow you to select parameters such as the
Site I.D. Message, Command Confirmation and other options and, in the Text
Interface it is also used to create passwords/accounts (In the Web Browser
Interface, passwords are created via the "Users" button in the Setup Menu.
• Web Browser Interface: Click the "Setup" button to access the Setup
Menus, and then click the "System Parameters" button. The System
Parameters Menu will be displayed as shown in Figure 5.3.
• Text Interface: Type /F and press [Enter]. The System Parameters
Menu will be displayed as shown in Figure 5.4.