I-Tech Company CMS 6R4 Series - Manual (Page 21)

4-1
4. Installation
This Section provides further details regarding installation of the CMS-6R4.
4.1. Power Supply Connection
Use the supplied power cord to connect the CMS-6R4 to an appropriate power
supply. Note that the CMS-6R4's Main Power switch must be "On" in order
for the unit to operate.
CAUTIONS:
• Before attempting to install this unit, please review the warnings
and cautions listed at the front of the user's guide.
• This device should only be operated with the type of power
source indicated on the instrument nameplate. If you are not
sure of the type of power service available, please contact your
local power company.
• Reliable earthing (grounding) of this unit must be maintained.
Particular attention should be given to supply connections when
connecting to power strips, rather than directly to the branch
circuit.
4.1.1. Installing the Cable Keeper
The CMS-6R4 includes a cable keeper, which is designed to prevent the power
supply cable from being accidentally disconnected from the unit.
When attaching the power supply cable to the unit, first swing the cable keeper
out of the way, then plug the power cable securely into the power input. When
the cable is in place, snap the cable keeper over the plug to secure the cable to
the unit.
4.2. Connecting Devices to the Switched Outlets
Connect the power cord from your switched device to a switched AC Outlet on
the CMS-6R4 back panel. Note that when power is applied to the CMS-6R4,
the Switched AC Outlets will be switched "ON". Note that the CMS-6R4
(120 VAC Model) is designed for 100 to 120 VAC operation and will support
up to 15 Amps maximum, and the CMS-6R4-CE (230 VAC Model) is designed
for 100 to 240 VAC operation and will support up to 10 Amps maximum.