I-Tech Company CMS 6R4 Series - Manual (Page 59)

5-37
Confi guration
2. When the command prompt appears, invoke the /CP command as
described below. The menu shown in Figure 5.16 will be displayed.
a) All Ports: To copy parameters to all CMS ports, type
/CP and then
press [Enter].
b) Range of Ports: To copy parameters to a range of Serial Ports, type
/CP m-n and then press [Enter]. Where m and n are CMS port
numbers that specify the beginning and end of the desired range. For
example, to copy parameters to ports 3 through 5, type /CP 3-5
and then press [Enter].
c) Several Ports: To copy parameters to several Serial Ports, type
/CP m,n,x [Enter]. Where m, n and x are the numbers for the
desired ports. For example to copy parameters to ports 3, 5, and 7,
type /CP 3,5,7 [Enter].
d) Combination: To invoke the /CP command in a manner where a
range of Serial Ports is specified, along with other port(s) outside the
range, type /CP m-n,x [Enter]. Where m, n and x are Serial Port
numbers. For example to copy parameters to Ports 2 through 4, plus
Port 6, type /CP 2-4,6 and then press [Enter].
3. Selecting Parameters: To select parameters to be copied, key in the
number for the desired parameter, press [Enter], and then follow the
instructions in the submenu. Note that it is not necessary to define all port
parameters; for example, the /CP command could be used to select only
the Baud Rate for all specified ports.
4. Clear Menu: After defining several parameters, if you wish to clear the
/CP menu and start again, type - (dash) and press [Enter]. The Copy
Parameters menu will be reset.
5. Exit Without Copy: To exit from the Copy Parameters menu without
copying selected parameters to the selected Serial Ports, type X and then
press [Enter]. The CMS-6R4 will exit from the Copy Parameters menu.
6. Copy Parameters: When you have finished selecting parameters, press
[Esc] to copy the selected parameters to the Serial Ports. If the "Sure"
confirmation prompt is displayed, type Y to proceed or N to abort the
command.