I-Tech Company CMS 6R4 Series - Manual (Page 56)

5-34
CMS-6R4 Series - User’s Guide
• Direct Connect: Direct Connect allows you to access the CMS-6R4
and automatically create a connection between the Network Port and a
specific RS232 port by including the appropriate Telnet port number in
the connect command (e.g. Port 5 = 2105). For more information, please
refer to Section 6.6. As described below, the Direct Connect feature
offers three options. (Default = Off.)

Off: Telnet users will not be able to employ the Direct Connect feature
to connect to this port.

On - No Password: Telnet users will be able to employ the Direct
Connect feature to connect to this port without entering a password.

On - Password: Telnet users will be able to use Direct Connect to
connect to this port, but will be required to enter a password before the
connection is established.
Note: If "On - Password" is selected, and Supervisor commands are
disabled at the Network Port, then only accounts that do not permit
Supervisor commands will be allowed to establish a direct connection
via the Network Port. If Supervisor commands are disabled at a given
port, then that port will not allow access by accounts that permit
Supervisor commands.
When the Port Parameters menu is accessed via the Text Interface, the
menu also lists both Direct Connect port numbers for this port (port
numbers are not listed in the Web Browser Interface.)

Telnet Port: The Telnet port number that is used to create a Direct
Connection to this port using standard Telnet protocol.

Raw Port: The Telnet port number that is used to create a Raw Socket
connection to this port. When Raw Socket Mode is used, data is
always sent "as is", and command echo is always enabled.