I-Tech Company CMS 6R4 Series - Manual (Page 31)

5-9
Confi guration
The System Parameters Menus allow you to define the following parameters:
• Site ID: Defines a brief text message, which can describe the location or
function of the CMS-6R4 unit. (Up to 32 characters,
Default = undefined.)
Notes:
• The Site ID Message cannot begin with a forward slash ( /) or
backslash ( \) character.
• The Site ID Message cannot include non printable characters or
quotation marks.
• Command Confirmation: When enabled, the CMS-6R4 will display
a confirmation prompt before executing certain commands. When
disabled, the prompt will be suppressed and commands will be executed
immediately. (Default = On/Enabled.)
• Automated Mode: When enabled, the CMS-6R4 will execute port
connection/disconnection, switching, reboot and exit commands without
displaying a confirmation prompt, status screen or confirmation messages.
For more information, please refer to Section 6.5. (Default = Off.)
Note:
When this option is enabled, security functions are suppressed,
and users are able to access configuration menus and control plugs
without entering a password. If security is a concern and the
Automated Mode is required, it is recommended to use the IP Security
feature (Section 5.5.2.1) to restrict access.
• Manual Switch Button: Enables/disables the Set Button's manual
plug control function, but does not effect the Set Button's ability to reset
parameters to default values. (Default = "On".)
▪ Off: Disables the manual plug control function.
▪ On: Enables manual plug control. When pressed and held for three
seconds, all outlets will be toggled On or Off.
• Command Prompt: Allows the Text Interface command prompt to be
set to either "CMS", "NPS", "IPS" or "NBB." (Default = CMS.)
• Password on Dial Back: Enables/Disables the "Password on Dial Back"
feature as described in Section 5.5.1.6. (Default = Off.)
• Dial Back Attempts: Sets the number of times that the CMS-6R4
will attempt to call the dial back number when the Dial Back feature is
properly configured and enabled, and you attempt to access command
mode via Modem. For more information on the Dial Back feature, please
refer to Section 5.5.1.6. (Default = 3.)