I-Tech Company CMS 6R4 Series - Manual (Page 55)

5-33
Confi guration
• Inactivity Timeout: Enables and selects the Timeout Period for this port.
If enabled, and the port does not receive or transmit data for the specified
Timeout Period, the port will disconnect and exit command mode.
(Default = 5 Minutes.)
Note:
When connected ports time out and are disconnected, both
ports will also exit from command mode.
• Response Type: Selects the type of messages that this port will send in
Text Interface mode when responding to commands. The user can select
Verbose (English Text), Terse (Numeric / Abbreviation), or Quiet Mode
(No Response). (Default = Verbose.)
• Command Echo: Enables or Disables the command echo for this port.
(Default = On).
• Accept Break: Determines whether this port will accept breaks received
from the attached device, and pass them along to a connected port. When
enabled, breaks received at this port will be passed to any port that this
port is connected to, and sent along to the device connected to the other
port. When disabled, breaks will be refused at this port, and hence, not
sent to the other port. (Default = Yes.)
• Invalid Access Lockout: Enables/Disables the Invalid Access Lockout
feature at this port as described in Section 5.5.2.3. Briefly, the Invalid
Access Lockout feature can be used to automatically disable a port when
a user-defined number of invalid access attempts are detected.
(Default = Off.)