I-Tech Company CMS 6R4 Series - Manual (Page 61)

5-39
Confi guration
5.5.5. Plug Parameters Menus
The Plug Parameters Menus are used to define Plug Names, Plug Passwords,
boot/sequence delay times and Power Up Default values for each of the
CMS-6R4’s Switched AC Outlets.
• Web Browser Interface: Click the "Setup" button to access the
configuration menus, then click the "Plug Parameters" button. The Plug
Parameters Menu will be displayed as shown in Figure 5.17.
• Text Interface: Type /PL n and then press [Enter] (Where n is the
number or name of the plug you wish to configure.) The Plug Parameters
Menu will be displayed as shown in Figure 5.18.
Note that in this case, the major difference between the Web Browser Interface
and Text Interface is that the Web Browser Interface allows you to select
parameters for all plugs from a single menu, whereas the Text Interface
includes a separate menu for each plug.
The Plug Parameters Menu allows you to define the following parameters:
• Plug Name: (Up to 16 Characters, Default = undefined.)
Note: Plug Names cannot begin with a number, dash ( -), underscore
character ( _), forward slash character (/) or backslash (\) character,
and cannot include non printable characters, spaces, asterisks ( *),
colons ( :), the plus symbol (+) or quotation marks.
• Boot/Seq. Delay: When more than one plug is switched On/Off or
a reboot cycle is initiated, the Boot/Sequence delay determines how
much time will elapse between switching operations, as described in
Section 5.5.5.1. (Default = 0.5 Second.)
• Power Up Default: Determines how this plug will react when the
Default command (/DPL) is invoked, or after power to the unit has been
interrupted and then restored. After the default command is invoked, or
power is restored, the CMS-6R4 will automatically switch each plug On
or Off as specified by the Power-Up Default. (Default = On).
Note:
The Default Plugs command (/DPL) is only available to
passwords and ports that permit access to Supervisor Level commands.