I-Tech Company CMS 6R4 Series - Manual (Page 48)

5-26
CMS-6R4 Series - User’s Guide
• Supervisor Mode: Permits or denies access to Supervisor Mode via
Telnet. When disabled (Deny), the port will not enter Supervisor Mode,
even when a password that normally permits access to Supervisor Mode
is entered. (Default = Permit.)
• Logoff Character: Defines the Logoff Character for the Telnet port. The
Logoff Character determines the command(s) or character(s) that must
be issued in order to disconnect the Telnet Port from a CMS-6R4 RS232
Serial Port (Resident Disconnect). (Default = ^X ([Ctrl] plus [X]).)
Notes:
• When redefining the Logoff Character, make certain to select a
character that does not normally occur in your data.
• The Logoff Character is only used when disconnecting a Resident
Connection via the Text Interface.
• Sequence Disconnect: Enables/Disables and configures the Resident
Disconnect command. This prompt offers the option to either disable the
Sequence Disconnect, or select a one character format or a three character
format. (Default = One Character). Note the following:
• When a Resident Connection is initiated, the CMS-6R4 will send a
message which lists the connected ports, and displays the one character
or three character command that will be required in order to disconnect.
• The One Character Disconnect sequence is intended for situations
where the destination port will not receive the disconnect command.
When the Three Character format is selected, the disconnect sequence
will pass through to the destination port prior to breaking the
connection.
• When the One Character format is selected, resident connections are
terminated by entering the selected Logoff Character only. There is no
need to press [Enter] before and after the Logoff Character when the
One Character format is selected.
• When the Three Character format is selected, the Resident Disconnect
Sequence will use the format "[Enter] LLL[Enter]", where L is the
selected Logoff Character.