I-Tech Company CMS 6R4 Series - Manual (Page 91)

7-5
The Status Screens
7.4. The Port Parameters Screen (/W)
7.4.1. Port Parameters Screen - Serial Ports
The /W (Who) command can be used to display the Port Parameters Screen,
which lists more detailed information about an individual port. The Port
Parameters Screen can display information for Serial Ports (Figure 7.4) or
the Network Port, and is only available when you have logged into command
mode using a password that permits access to Supervisor Level commands.
For more information on the various items displayed on the Port Parameters
Screen, please refer to the port configuration description in Section 5.5.3.
When the /W command is applied to a Serial RS232 Port, the following format
is used:
/W x [Enter]
Where x is the number for the Serial Port that you wish to display.
PORT PARAMETERS #3:
1. Port Name: (undefined) 15. Direct Connect: Off
2. Baud Rate: 9600 Telnet Port: 2103
3. Bits/Parity: 8-None Raw Port: 3103
4. Stop Bits: 1
5. Handshake Mode: RTS/CTS
6. Port Mode: Any-to-Any
64. DTR Output: Pulse
7. Supervisor Mode: Permit
8. Logoff Character: ^X
9. Sequence Disconnect: One Character Only
10. Inactivity Timeout: 5 Min
11. Response Type: Verbose
12. Command Echo: On
13. Accept Break: Yes
14. Invalid Access Lockout: Off
CMS>
Figure 7.4: The Port Parameters Screen (Serial Port 3 Shown)