Lexmark 3455 - Manual (Page 127)

127
8.8 Twinax Interface Settings
Only three setting options have to be considered to set up the Adapter for SCS for
IPDS operation:
SCS Device Address
IPDS Device Address
IPDS Buffer Sizes
Note: Be certain to set the correct twinax address for both the SCS address and the
IPDS address before physically connecting your printer to the twinax wiring
system. If you were to incorrectly enter the same address used by another
device, you would disable that device. If you do not know your printer’s
correct address, see your network administrator.
8.9 SCS Device Address Setting
The SCS Device Address is used to select the twinax device address for the SCS
emulation or to disable the SCS emulation if you don’t want to use it. From the printer
operator panel, do the following:
1. Press Menu> until NETWORK MENU displays. Press Select.
2. Press Menu> to display NETWORK OPTION 1. Press Select. (This
example assumes the Adapter for SCS is installed in option connector 1.)
3. Press Menu> to display SCS MENU 1. Press Select.
4. Press Menu> to display SCS OPTIONS. Press Select.
Press Menu> until you find the following setting:
SCS Dev. Addr. 0
(Address can be “0” – “6” or “Disable”)
Note: If the IPDS emulation and the SCS emulation are given the same address,
the SCS emulation is used and the IPDS emulation is ignored. The word
DUPLICATE is displayed in the operator panel.