Lexmark 3455 - Manual (Page 43)

43
4.3.15 Trace Functions
This option determines if the Trace function is enabled. Trace data is sent to either the
serial or parallel port. Unless you have a computer running a capture program attached
to the serial or parallel port to receive the trace data, the printer will hang Busy and
display IPDS on the first line of the operator panel and TRC on the second line of the
operator panel.
Note: The Trace function is used by service personnel for troubleshooting and
service.
Disable* Disable Trace
Serial Output Enable serial port for output of trace data
Parallel Output Enable parallel port for output of trace data
Note: Some Optra models do not have a serial port standard on the printer. A Tri-
Port Adapter must be installed in printer option card slot one to perform
serial tracing on these models.
Note: This option cannot be changed remotely.
4.3.16 IPDS Version
This option displays the current IPDS level in the second line of the operator panel.
The IPDS level is also printed whenever the Menu Settings are printed. Refer to
section 2.2 Printing the Menu Settings on page 13.
Note: This option cannot be changed remotely.
Note: The IPDS Version option is only available on IPDS code level 9241 or
above.