Lexmark 3455 - Manual (Page 87)

87
7.3 Configuring a MarkNet Pro External Print
Server
To enable IPDS printing with the MarkNet Pro several settings must be changed.
Changes to MarkNet Pro settings can be made using the appropriate network printer
utilities. For more information on how to change these settings, refer to your Lexmark
MarkNet Pro network adapter manual which came with your print server.
N
Network Adapter User's Guide or
N
Network Adapter Hardware Setup
7.3.1 Printing a MarkNet Pro Setup Page
The MarkNet Pro Microcode Level must be: 2.9.15 (or greater)
To see the code level, you need to print the setup page. To print the MarkNet Pro setup
page, press and release Menu and Test simultaneously. Under the Network Card
heading on the Setup Page, look for Firmware Revision.
For more information, see Lexmark’s Network Printer Utility Guide.
If you need to update your MarkNet code level, contact the Lexmark Technical Support
Center. MarkNet Pro firmware updates are also available from the Lexmark web site at
http://www.lexmark.com .
7.3.2 Setting the MarkNet Pro TCP/IP Protocol Settings
The following TCP/IP protocol settings must be set in order for the host to send jobs to
the printer through the MarkNet Pro. Contact your network administrator if you need
help with these settings.
Activate Yes
Set IP Address 157.184.67.102
(Address available from your network administrator)
Set IP Netmask 255.255.255.0
(Appropriate netmask for your network)