Lexmark 3455 User Manual
Page 136
136
IPDS Timeout = 15 seconds to 10 minutes (when using a MarkNet internal print
server only)
If you selected the IPDS Timeout value of Host Controlled to allow the host to
directly control ending (disconnecting) a LAN session, go to IPDS Timeout =
Host Controlled on page 135.
If you selected an IPDS Timeout value of 15 seconds to 10 minutes to allow the
printer IPDS emulation to determine when an IPDS LAN session times out,
follow the steps below to correct the problem.
1.
Adjust the MarkNet internal print server end-of-job timeout value to 0
(disabled). See 7 Using the SIMM for IPDS with a MarkNet Internal or
External Print Server on page 83 for additional information.
2.
Change the host port setting to 9600. Refer to IPDS Timeout on page 40 for
further information on the selection of ports.
3.
Correct the appropriate host timer/timeout value as shown below.
Note:
The host timer/timeout values below should not be used with a
host port value of 9100 or 9102.
PSF/400 with OS/400 V3R1 or V3R6
WRKAFP2: Inactivity Timer (INACTTMR)
*NOMAX
PSF/400 with OS/400 V3R2, V3R7, V4R1, V4R2, V4R3, or V4R4
CRTPSFCFG: Release Timer (RLSTMR)
*NOMAX
PSF/MVS
PSF Startup Proc: Disconnect Interval (DISCINTV)
0
PSF/2
TCP/IP Settings: Connect Timeout
0
Tuning Option: Job Interval Shutdown Timer
9999
PSF/AIX
SMIT Printer Def: Connect Timeout
0