Lexmark 3455 - Manual (Page 41)

41
15 seconds
30 seconds
60 seconds
90 seconds
2 minutes
3 minutes
5 minutes
10 minutes IPDS emulation timeout value. These values are only used by
the printer IPDS emulation when the host sends IPDS jobs on
port 9600 to a MarkNet internal print server. If the host does
not send another IPDS job or send additional IPDS resource
data to the printer within the timeout value specified, the
printer IPDS emulation will time out, place all IPDS resources
in temporary storage (see Storage of IPDS Resources below),
and allow the printer to print jobs from other printer ports.
Host Timer/Timeout Values and Actions: While the printer is
printing jobs from other printer ports, the host is still connected
to the printer. The host timer/timeout value should be disabled
or set to a large value to prevent the host from disconnecting
and deleting the resources downloaded to the printer.
Note:
N
Up to four different LAN sessions may be active on port 9600.
Requests for additional sessions will be ignored until the host
disconnects from one of the established sessions.
N
The IPDS Timeout values are not active when the printer is
connected to a host through an Adapter for SCS card. The IPDS
timeout is controlled by the Coax or Twinax timeout value on
the Adapter for SCS card.
N
The IPDS Timeout value defaults to Host Controlled when the
printer is connected to a host through a MarkNet Pro external
print server or MarkNet XLe print server. The host port value
must be 9100 or 9102 to communicate with these print servers.
See Storage of IPDS Resources on next page for additional information.