Perle Systems 833IS - Manual (Page 193)

Chapter 9: Configuring the Server
Perle 833IS User Guide 177
key card. If the user ID and token are authenticated by the Axent server, the user will
be granted access.
A remote Client must support terminal mode to use Axent security. Client
configuration may be required to enable this mode.
Users will be given the privileges granted in the Standard User Profile. See
“Standard Profile” on page 155. However, you can add a user record to the Internal
833IS User Database to define unique privileges. The User ID field must match the
user ID in the Axent server. The password in the Internal User Database will not be
used unless the user is requesting administration privileges.
The Axent screen contains the following:
Protocol
Select IPX/SPX or TCP/IP as the protocol used to communicate with the Axent
server. The protocol chosen will change the Primary and Backup Server Address
fields described below.
Agent Key
Enter the Agent Key for the 833IS. This is a 1 to 16 digit hexadecimal value and
must match the Agent Key configured on the Axent server. This key is used to
authenticate the 833IS as a valid Axent agent.
Confirm Agent Key
Re-enter the Agent Key in this field for confirmation.