Perle Systems 833IS - Manual (Page 285)

Appendix 2: AT Command Set
Perle 833IS User Guide 269
ECC Commands %C0 Disable data compression.
%C1 Enable MNP 5 data compression.
%C2 Enable V.42 bis data compression.
%C3 Enable both V.42 bis and MNP 5 compression.
\A0 Set maximum block size in MNP to 64.
\A1 Set maximum block size in MNP to 128.
\A2 Set maximum block size in MNP to 192.
\A3 Set maximum block size in MNP to 256.
\Bn Send break of n x 100 ms.
MNP 10 Commands -K0 Disable MNP 10 extended services.
-K1 Enable MNP 10 extended services.
-K2 Enable MNP 10 extended services detection only.
-SEC=0 Disable MNP10-EC.
-SEC=1,[<tx level>]Enable MNP10-EC and set transmit level <tx level> 0 to 30 (0
dBm to -30 dBm).
FAX Class 2 +FCLASS=nService class.
+FAA=n
Adaptive answer.
+FAXERR Fax error value.
+FBOR
Phase C data bit order.
+FBUF? Buffer size (read only).
+FCFR Indicate confirmation to receive.
+FCLASS= Service class.
+FCON
Facsimile connection response.
+FCIG Set the polled station identification.
+FCIG: Report the polled station identification.
+FCR Capability to receive.
+FCR= Capability to receive.
+FCSI: Report the called station ID.
+FDCC= DCE capabilities parameters.
+FDCS: Report current session.
+FDCS= Current session results.
+FDIS: Report remote capabilities.
+FDIS= Current sessions parameters.
+FDR Begin or continue phase C receive data.