Perle Systems 833IS - Manual (Page 49)

Chapter 3: Setting Up and Installing
Perle 833IS User Guide 33
IP Default Router Address
If the IP network path to the Management Connection passes through an IP router
(gateway), enter the IP address of the router that is on the same LAN segment as the
833IS and is responsible for forwarding the IP packets to the network to which the
Management PC is connected.
Set up the basic
parameters The LAN cable should not be connected to the 833IS at this time. Power up the
833IS by turning on the power switch at the rear. The power LED should be lit.
The Front Panel will display:
After 5 seconds, the display will change to:
This indicates that the 833IS is not communicating with a Manager.
Using the
Front Panel
When the 833IS is received from the factory there is no configuration within the
unit. The Front Panel is in "Factory mode", and lets you:
■ Set the parameters needed for communication with the Management PC
■ Monitor the 833IS's operation on the network to verify correct configuration and
provides information to diagnose network problems.
You navigate through the Front Panel screens as follows:
Left , Right Keys
Selects a menu.
Up , Down Keys
View entries within a menu.
Enter Key
If an item can be edited, enables the item to be edited.
ESC
Return to the previous screen.
Perle 833IS
No Manager