Perle Systems 833IS - Manual (Page 251)

Appendix 1: Menu Descriptions and Maps
Perle 833IS User Guide 235
Factory Default Mode
Factory Default Setup
Provides the base configuration for the 833IS so that it can communicate with the
Manager
.
Menu Description
Perle 833IS Appears for 5 seconds on power up.
Manager Status Indicates whether the Perle 833IS Manager is
communicating with the server and which protocol is used
for communication. If the 833IS receives an IP ping
command in Factory Default mode, this message will
display, with the address of the device that sent the ping
command.
Menu Description
Manager Setup Indicates the start of the Factory Mode Setup displays.
IP Address Set IP address of the unit. Will indicate “none” if none has
been configured. When none appears, the 833IS will
attempt to acquire an IP address by BOOTP or RARP.
IP Subnet Mask Set IP subnet mask of unit. Will indicate “none” if none has
been configured. When none appears, the 833IS will use a
subnet mask of 255.255.255.0
Default Gateway Set IP default router address for the 833IS. This will be
required if the 833IS is not on the same segment as the
833IS Manager.
LAN Speed Options are 4 Mbps, 16 Mbps. Will indicate “not set” if the
speed has not been set by this configuration. If the speed
has not been set, the 833IS will not attempt to get on the
ring.