Perle Systems 833IS - Manual (Page 312)

Monitoring the 833IS
296 Perle 833IS User Guide
This command is used by the router to determine which image <filename> to load at
startup or when the
reload command is executed.
Monitoring the 833IS
In Cisco Configuration Mode, you are able to monitor statistics and the status of the
833IS. During your Telnet session, you can execute the show commands which
retrieve the latest statistics and are displayed on your Telnet interface.
The 833IS can also send Event Log messages in real time to up to 4 Syslog servers
concurrently. These Syslog servers can be attached to either the LAN or the WAN
interfaces. Configuration of the Syslog servers can be performed through the 833IS
Manager or using the following Cisco command:
logging <syslog host>
To trap specific event messages such as critical or informational events you can use
the following Cisco command:
logging trap <trap level>
For further detailed information regarding the logging Cisco commands, please refer
to the complete set of supported Cisco and Perle commands found on Perle Systems
Ltd. website www.perle.com.
Differences between 833IS Manager and Cisco Configuration Mode
The 833IS Manager is a Windows software application designed specifically to
configure and manage the 833IS unit. However, the Cisco Configuration Mode
provides an easy transition for personnel trained in Cisco configuration to manage
and setup the 833IS. Some of the methods and procedures used by the 833IS
Manager are handled differently than commands used in Cisco Configuration Mode.
In Cisco Configuration Mode, the onboard flash is treated as a disk drive. Firmware
images and configuration files are written to the flash as files and are managed with
TFTP commands. This allows the full capacity of the flash to be utilized with
multiple configuration and firmware images. However, once files have been written
to flash it cannot be erased unless the entire flash volume is erased. Although,