Perle Systems 833IS - Manual (Page 43)

Chapter 3: Setting Up and Installing
Perle 833IS User Guide 27
Modem
Interface
The card may include 8 central site modems on board. These modems will support a
rate of up to 56K using the V.90 or 56Kflex protocol. These modems can be used to
accept incoming analog calls or to establish outgoing calls.
Please take a moment to identify the type of cards present in your 833IS.
Serial Number
Label This label contains such information as the name and model of the unit, the serial
number for the unit, power requirement information as well as the various types of
approvals registered for the unit. The serial number label can be found on the bottom
of the unit.
Power Switch This switch is used to turn off all power to the unit. When the power is cycled, the
unit will restart its power up sequence. The 833IS can maintain its program and log
information event when no power is applied to the unit.
Assembling the Hardware
Connect the Power
Cord Connect one end of the supplied power cord into the 833IS power connection and the
other end into a properly grounded electrical outlet.
For safety, this equipment is designed to be electrically grounded. The 833IS must
be connected to a three wire grounded outlet only. The power cord supplied include
a third (grounding) pin. If you are unable to insert the plug into an outlet, contact
an electrician to replace the outlet with a properly grounded outlet.