Perle Systems 833IS - Manual (Page 53)

Chapter 3: Setting Up and Installing
Perle 833IS User Guide 37
Verifying Connection
On the LAN card, there is a Link LED which flashes to indicate network activity. If
this LED does not flash, check the physical cabling between the 833IS LAN adapter
and the Hub or MAU (Multistation Access Unit).
The Front Panel provides status information that allows you determine whether the
833IS basic configuration is correct. The menu structure for the Front Panel in
Factory mode is shown in the diagram below.
† Can be configured only when the unit includes Ethernet interface.
Status Fields are listed in the following section. A complete description of Front
Panel Factory Mode is found in “Factory Default Mode” on page 235, and “Factory
Default Mode” on page 237.
Status
IP
IP Frames Tx
IP Frames Rx
# RIP Entries
Address Found
By
IP Address
IP Subnet Mask
Manager
Setup
IP Subnet Mask
IP Address
IP Router Addr
LAN Speed
Status
Status
LAN
MAC Address
Port
Speed
Status
IPX
IPX Frames Tx
IPX Frames Rx
# RIP Entries
# SAP Entries
LAN Frames
Rx
Front Panel Factory Mode ▲
LAN Frames
Tx
Overruns
Port †
Manager
Status
Save Config