Download via tftp – Perle Systems 833IS User Manual
Page 75
Chapter 4: Using the Perle 833IS Manager
Perle 833IS User Guide
59
3.
A window box will appear displaying the Firmware version that you are about
to download. Confirm the download by clicking “OK”. The download will begin
and the TFTP Server window is displayed indicating the progress of the
download.
4.
After the download had completed, the Manager will display “Download
complete”. The following dialog box will appear:
5.
For the Firmware to take effect, the 833IS must be restarted. When the Server
has completed its restart, it will appear in the Server List Window. If you choose
to restart the 833IS, any existing sessions will be abruptly terminated.
Note: After the firmware download is completed, you can download the
configuration before restarting the 833IS.
The download should not be interrupted. If the download does not complete, do not reset the
833IS. Restart the Manager and download the Firmware again.
If the 833IS is reset before the download completes, the target 833IS will revert to
Factory Default Mode.
Although you can download the Firmware from a Dial-In connected Manager, it is
strongly recommended that this be done from a LAN connected Manager.
Download via TFTP
Firmware can be downloaded to the 833IS via TFTP. For details, please refer to
“Appendix 5: Cisco Configuration Mode”.