Pitney Bowes J640 - Manual (Page 100)

The following table describes each parameter you can set with
the Control Characters record.
Parameter Original Setting Description
Identifier E Control Characters Record
{
(left
bracket) ~123 Start of Packet
,
(comma) ~044 Parameter separator (delimiter)
"
(quotes) ~034 Quoted character string
p
(pipe sign) ~124 Field separator
}
(right
bracket) ~125 End of packet
~~
(double
tilde) ~126 Data escape character
must be user
defined any 1 character in the 0 to 255
hex range Immediate command character
string 1 0 to 3 characters each in the 0 to
255 hex range
NOTE:
The default is none.
Sending ""
disables this
sequence.
Terminator for status requests
string 2 0 to 3 characters each in the 0 to
255 hex range
NOTE:
The default is
"CRLF".
Terminator for job requests
and data uploads.
n
✦ The values shown are the defaults.
✦ After you change these parameters, all packets, including
any future configuration packets, must use the new control
characters. Pitney Bowes recommends using the tilde and
ASCII character code sequence when sending this record
multiple times. You must send record E to enable the
immediate commands. An immediate command will
execute immediately, even if it is embedded within
quotation marks, and all data following the command in the
string will be ignored. Pitney Bowes also recommends that
you set the packet delimiters to characters within the 21
hex to 7E hex range.
J640 Programmer’s Manual
5-14