Pitney Bowes J640 - Manual (Page 105)

Command Parameter
^CA Cancels all the batches in the queue.
^CB Cancels only the current batch being printed.
^DD or DCd Disables the MPCL data escape character and inhibits MPCL from
acting on ANY data escape sequence from the host. Sets the MPCL
data escape character to the ACSII value given by the d parameter.
The value can be any ASCII character.
^EA Aborts an error condition. May need to be sent multiple times.
CAUTION: Command causes the current batch to stop and the
condition that caused the error to remain uncorrected.
^ER Resets the error. This command is the same as pressing the trigger to
acknowledge an error. Normal operation will resume.
^FD Feeds a label when printer is idle. Simulates the operation of the
trigger and dispenses the next label if printer is in the on-demand
mode.
NOTE:
Printer ignores this command if printing.
^ID or ^ICd Disables the Immediate Command feature by turning off the Immediate
Command escape character. d is the ASCII value of the new control
character. Sets the Immediate Command escape character to the
ASCII value given by the d parameter. The value can be any ASCII
character.
^MM Used to identify the model number.
50 =
J640/J641
^MP Used to identify the prototype number. (00 to 99)
^MR Used to identify the revision number. (00 to 99)
^MV Used to identify the version number. (00 to 99)
^PR Resets the printer. This command takes five seconds to complete.
CAUTION: Command should be used only when the printer is
not printing.
^RB Repeats the last printed batch, printing the same number of labels as
specified in the original batch.
NOTE: Printer ignores this command if printing.
^RS Resynchronizes supply when supply roll is changed. Printer sends the
next label to the printhead so printing begins at beginning of the label.
NOTE:
Printer ignores this command if printing.
^SD or
^SCd
Disables the status polling feature by turning off the status polling
control character. d is the ASCII value of the new control character.
Sets the status polling control character to the ASCII value given by
the d parameter. The value can be any ASCII character.
^TP Prints a test label.
NOTE:
Printer ignores this command if printing.
Co
nf
igu
ring
t
h
e P
rin
te
r
Chapter 5. Configuring the Printer
5-19