Pitney Bowes J640 - Manual (Page 218)

Communication/ Hardware Failures –––––––––––––––––––––––––––
Errors 409 to 415 are usually caused by a hardware failure, by
an incorrect SETUP option or by the host ignoring flow control
(XON/OFF, CTS/RTS or DTR).
n
The valid options for printer Port Settings are shown below.
The default values are shown in bold.
Baud rate 1200, 2400, 4800, 9600, 19200
Word length 7 or 8
Stop bits 1 or 2
Parity Odd, Even, None
Flow control None, Xon/Xoff, DTR, CTS/RTS
Reset Yes or No
Error
Code Description/Action
409 The printer memory is full. Delete unnecessary
formats or graphics from memory. If you are using a
graphic file that is very large, consider using another
mapping method (such as run length encoding) to
reduce the required memory.
410 Parity on the printer does not match the parity on
the host. Check the parity setting under SETUP
options.
411 Framing error. The printer cannot communicate with
the host. Make sure the host is turned on,
communication cables are connected correctly, Port
Settings are correct, and communications are active.
Do not toggle between MS-Windows and MS-DOS,
while using the COPY command, or you will receive a
framing error. (Exit MS-Windows before using the
COPY command.) Re-transmit the data.
E
rro
rs
Chapter 11. Errors
11-13